Installation
Continued
7.Repeat steps 1 through 6, page 9, for other side.
8.Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets. Place the assembled trim onto fireplace cabinet. Align hanging notches on trim with hang- ing screws on side of fireplace (see Figure 7). Push trim firmly into place, sliding hanging notches over hanging screws.
Trim
Hanging
Screws
Hanging
Notches
on Trim
Assembled
Trim
Figure 7 - Attaching Perimeter Trim to
Fireplace
Minimum Clearance to
Combustible Materials
Top: 42", Left and Right Sides: 16" Bottom and Rear: 0", Front: 36"
Example
*
*Minimum 16" from Side Wall
Figure 8 - Minimum Clearance for
Combustible to Wall
Conventional Fireplace Installation
Conventional installation of this fireplace involves installing fireplace along with the corner, face or cabinet mantel with hearth base accessories against a wall in your home. Follow the instructions below to install the fireplace in this manner.
INSTALLATION CLEARANCES
WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceiling and adjoining wall.
Carefully follow the instructions below. This will ensure safe installation.
Minimum Clearances For Side Combustible Material, Side Wall and Ceiling
A.Clearances from the side of the fireplace cabinet to any combustible material and wall should follow diagram in Figure 8.
Example: The face of a mantel, bookshelf, etc. is made of combustible material and protrudes 3 1/2" from the wall. This com- bustible material must be 4" from the side of the fireplace opening (see Figure 8).
B.Clearances from the top of the fireplace opening to the ceiling should not be less than 42".
1.Assemble cabinet mantel, hearth base and trim accessories. Assembly instruc- tions are included with each accessory.
2.When installing blower, install a properly grounded, 120 volt
Figure 9).
| Rigid | Electrical | Gas | |
Hearth | Outlet | Line | ||
Gas | ||||
Base |
| Access | ||
Line |
| |||
|
| Hole | ||
|
|
|
Figure 9 - Placing Hearth Base
Accessory Against Wall
10 | www.desatech.com |