Installation
Continued
Note: Your fireplace is designed to be used in zero clearance installations. Wall or framing material can be placed directly against any exterior surface on the rear, sides or top of your fireplace, except where standoff spacers are integrally at- tached. If standoff spacers are attached to your fireplace, these spacers can be placed directly against wall or framing materials.
Use the dimensions shown for rough openings to create the easiest installation. See
IMPORTANT:
IMPORTANT: Make sure the fireplace is level. If fireplace is not level, log set will not work properly.
CHECK GAS TYPE
Use the correct gas type (natural or propane/ LP) for your fireplace. If your gas supply is not correct, do not install fireplace. Call dealer where you bought fireplace for proper type fireplace.
WARNING: This appliance is equipped for either natural gas or propane/LP gas but not both. Gas type is indicated on the rating plate. Field conversion is not permitted.
ELECTRICAL HOOKUP
(Models GA3700 Series and GA3700T
Series Blower Accessories and GA3555
Internal Duplex Kit)
This fireplace accepts a blower assembly with an electrical cord. The electrical cord is five feet in length. You must locate fireplace within reach of a 120 volt grounded electrical outlet. If not, you must install an electrical outlet within reach of fireplace power cord. The GA3555 outlet accessory is used for
INSTALLING HOOD
Install hood to top of firebox as shown in Figure 5. Use 3 Phillips screws provided.
Figure 5 - Installing Hood to Firebox
Assembling and attaching OPTIONAL perimeter trim (Included with Mantel Accessory)
IMPORTANT: If you are recessing the fire- box in a wall, do not attach perimeter trim at
this time. See
page 12.
Note: The instructions below show assembling
and attaching perimeter trim to fireplace.
1.Remove packaging from three pieces of perimeter trim.
2.Locate four perimeter screws, two adjust- ing plates with set screws and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 6.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top perimeter trim (see Figure 6).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side perimeter trim (see Figure 6).
6.While firmly holding edges of perimeter trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
| Set Screws | ||
| Adjusting | Top | |
Side Trim | Plate | ||
Trim | |||
| Shim |
| |
| Mitered | Slot | |
Slot | Edge | ||
|
|
Figure 6 - Assembling Perimeter Trim
www.desatech.com | 9 |