OPERATIon
Continued
4.Press in and turn control knob clockwise
to the OFF position.
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information, page 19. If you don’t smell gas, go to the next step.
6.Press in and turn control knob counter-
clockwise to the PILOT position.
Press in control knob for five (5) seconds
(see Figure 32).
Note: You may be running this heater for the first time after hooking up to gas sup- ply. If so, the control knob may need to be pressed in for 30 seconds or more. This will allow air to bleed from the gas system.
7.With control knob pressed in, press and release ignitor button. This will light pilot.
The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 21.
8.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob.
•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4 through 8.
9.Slightly push in and turn control knob coun-
terclockwise to the ON position.
10.Wait one minute and switch selector switch to the ON position to light burner.
|
| Ignitor Button |
Control Knob |
| |
IH |
|
|
N | O |
|
O | F | AUTO |
| F |
|
LO | TOLIP | OFF |
|
| ON |
Flame Adjustment | Selector Switch | |
Knob |
| |
|
|
Figure 32 - Control Knob and Ignitor
Button Location (Shown as Supplied, No
Control Options)
11.Set flame adjustment knob to any level between HI and LO.
12.To leave pilot lit and shut off burners only:
turn control knob clockwise to the PILOT position, or use remote control manual OFF button, or set selector switch in the OFF position.
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
WARNING: Make sure the selector switch is in the OFF positionwhenyouareawayfrom home for long periods of time. Fireplace will come on automatically with selector switch in the ON position.
Pilot Burner | Ignitor | |
Electrode | ||
| ||
Figure 33 - Pilot (Propane/LP) | ||
| Ignitor | |
Pilot Burner | Electrode |
Figure 34 - Pilot (Natural)
TO TURN OFF GAS
TO APPLIANCE
1.Turn control knob clockwise to the OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional
3.Close equipment shutoff valve (see Fig- ure 21, page 16).
20 | www.desatech.com |