Installation
Continued
Mounting
Clips
Notches
Screws for
Mounting Screen
Figure 26 - Installing Fireplace Screen
OPTIONAL Wireless
Installing Remote Receiver Unit
1.Disconnect switch wires from the con- trol valve.
2.Remove screws attaching switch plate.
3.Remove switch plate (see Figure 27).
Discard after removing.
4.Install remote receiver unit onto gas log heater base using mounting clips.
5.Push clips firmly into place (see Figure 28).
6.Connect wires as shown in Figure 29.
Remote | Ignitor |
Switch |
|
Bracket |
|
Screw
Switch Plate | Wires |
Figure 27 - Switch Plate and Wiring
Harness
Remote Receiver
Figure 28 - Installing Remote Receiver
White Wire
From Receiver
Valve
Red Wire From
Receiver
Figure 29 - Connecting Wires
Installing
Two
Note: Only use alkaline batteries.
Installing
1.Locate back of receiver under front burner of heater.
2.Locate the battery clip mounted on the back of the receiver.
3.Slide a
4.Attach the terminal wires to the battery.
Remote | Terminal Wires |
Receiver |
|
Battery Clip
Figure 30 - Installing Battery in Remote
Receiver
18 | www.desatech.com |