Installation
Continued
5.Correct all leaks at once.
6.Light fireplace (see Operation, page 19.
Check all other internal joints for leaks.
7.Turn off fireplace (see To Turn Off Gas to Appliance, page 20).
INSTALLING LOGS
CAUTION:Donotremovethe dataplatesattachedtotheheater base assembly. The data plates contain important warranty and safety information.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. WiththeheatersettoHigh,check to see if flame contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
1.Place back log #1 on grate to fit as il- lustrated in Figure 24. Make sure middle section at bottom of log set is seated into
2.Place front log #2 against front grate prongs as shown in Figure 24.
3.Place crossover log #3 on top of front and back logs as shown in Figure 24.
4.Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 26, page 18).
WARNING:Youmustoperate this fireplace with the fireplace screen in place. Make sure fireplace screen is in place before running fireplace.
| Crossover | |
| Log #3 | |
Front | Back | |
Log #2 | ||
Log #1 | ||
| ||
Grate |
| |
Prongs |
|
ChassisBurner
Figure 24 - Installing Log Set
Burner Ports | Log Set |
Figure 25 - Installing Log Set, Top View
www.desatech.com | 17 |