| FIREPLACE INSTALLATION | |
20 | ||
Checking Gas Connections (Cont.) | ||
| ||
| Installing Optional Wall Mount Switch - GWMS2 | |
|
|
FIREPLACE INSTALLATION
Continued
5.Reconnect fireplace and equipment shutoff valve to gas supply. Check reconnected fittings for leaks.
Test Pressures Equal To or Less Than 1/2 PSIG (3.5 kPa)
1.Close equipment shutoff valve (see Figure 33).
2.Pressurize supply piping system by either opening propane/LP supply tank valve for propane/LP gas fireplace or opening main gas valve located on or near gas meter for natural gas fireplace or using compressed air.
3.Check all joints from propane/LP supply tank or gas meter to equipment shutoff valve (see Figure 34, for propane/LP or Figure 35, for natural gas). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all
leaks at once.
Equipment | Open |
Shutoff |
|
Valve |
|
Closed
Figure 33 - Equipment Shutoff Valve
Pressure Testing Fireplace Gas Connections
1.Open equipment shutoff valve (see Figure 33).
2.Open propane/LP supply tank valve for propane/LP fireplace or main gas valve located on or near gas meter for natural gas fireplace.
3.Make sure control knob of fireplace is in the OFF position.
4.Check all joints from equipment shutoff valve to gas valve (see Figure 34 for propane/LP or Figure 35 for natural gas). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks at once.
5.Light fireplace (see Operating Fireplace, page 23). Check all other internal joints for leaks.
6.Turn off fireplace (see To Turn Off Gas to Appliance, page 24).
INSTALLING OPTIONAL WALL MOUNT SWITCH - GWMS2
1.Connect one terminal of 25 ft. wire for the wall switch to the TPTH terminal on the valve. Connect remaining wire terminal to the TH terminal on the valve. Make sure that the wire terminals are in the positions on the unit as pictured in Figure 36. If wires are not connected as shown the switch will not work.
2.Route the 25 ft. wire through openings provided on the sides of the burner system to a convenient location to mount your switch.
|
| 3. | Connect one bare wire end to each of the terminals of the | |
Propane/LP | Equipment |
| GWMS2 wall switch. | |
4. | Install the wall switch and cover in the wall. | |||
Supply Tank | ||||
Shutoff |
|
| ||
|
|
| ||
| Valve |
| To Wall Switch | |
|
|
| ||
|
|
| Accessory | |
| Gas Valve | Figure 36 - Connecting Wall Swith to Control Valve | ||
Figure 34 - Checking Gas Joints for Propane/LP Gas
Fireplace
Equipment |
Shutoff |
Valve |
Gas |
Meter |
Gas Valve |
Figure 35 - Checking Gas Joints for Natural Gas Fireplace |
www.desatech.com |
