![](/images/new-backgrounds/1026866/2686631x1.webp)
16
OPERATING HEATER
Lighting Instructions (Cont.)
To Turn Off Gas To Appliance
Manual Lighting Procedure
OPERATING HEATER
Continued
8.With control knob pressed in, press and release ignitor but- ton. This will light pilot. The pilot is attached to the rear of the front burner. If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure.
9.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs. Note: If pilot goes out, repeat steps 4 through 8.
10.Slightly push in and turn control knob counterclockwise to the ON position.
11.Press the on/off key on the remote control to turn on appli- ance main burner. Wait at least 5 seconds before setting desired flame height.
12.Press the up or down key until the small triangle is to the left of large flame icon at the top of LCD display (see Figure 29). Press the left or right key to set the desired flame height.
13.Replace control cover log (see Figure 26, page 15).
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
Note: The pilot flame on natural gas units will have a slight curve, but flame should be blue and have no yellow or orange color.
MANUAL LIGHTING
PROCEDURE
1.Follow steps 1 through 7 under Lighting Instructions, page 15.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions in column 1.
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot before using the
When the appliance and the remote control are switched off, the house icon with the room temperature will be displayed. When the remote control is turned on, other icons will be visible and the main burner of the appliance will turn on.
1.Turn control knob clockwise to the ON position (see Figure 25, page 15).
2.Press the ON button on remote control (see Figure 29). Wait 5 seconds to send a command to appliance.
Note: An acoustic signal will be heard that confirms the recep- tion of the command sent from the remote control.
Pilot Burner | Ignitor | Pilot Burner | Ignitor |
Electrode | |||
| Electrode |
|
|
Figure 27 - Pilot (Propane/LP) Figure 28 - Pilot (Natural)
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
Press on/off key on remote control and turn control knob
clockwise to the OFF position (see Figure 25, page 15).
Shutting Off Burners Only (pilot stays lit)
Press the on/off key on remote control or turn control knob
clockwise to the PILOT position.
Small Triangle
Icon (Function
Indicator)
Flame Height
Indicator
Thermometer
Icon
Clock Icon
Left and Right
Keys Increase
and Decrease
Set Points
On/Off Button
LCD Display
Room
Temperature
Display
Sleep Timer
Display
Indicator
Low Battery
Indicator
Up and Down
Keys Select
Available
Functions
Figure 29 - Remote Control
For
.
.com