INSTALLATION
Installing Batteries For Remote Receiver and
OPERATING HEATER
For Your Safety Read Before Lighting
Lighting Instructions
17
INSTALLATION
Continued
INSTALLING BATTERIES FOR REMOTE RECEIVER AND HAND HELD REMOTE CONTROL
Four AA batteries and three AAA batteries are required to operate this heater with the wireless
Installing Batteries in Receiver
1.Locate slot on battery cover of receiver (see Figure 32). Firmly insert tool such as a small screwdriver, butter knife, or dime into the slot and lift up to remove cover.
2.Insert 4 AA batterines into receiver. Positive and negative are marked inside receiver casing. Note: Receiver will not func- tion if batteries are not installed correctly.
3.Slide tab on cover into receiver housing and snap cover back into place.
| Cover |
4 AA |
|
Batteries |
|
Battery | Slot |
Housing |
|
Backup | Receiver |
Switch |
|
Figure 32 - Installing Batteries in Receiver
Installing Battery into Remote
1.Remove remote cover (see Figure 33).
2.Insert 3 AAA batteries into remote control (see Figure 33). Posi- tive and negative are marked inside remote control casing. Note: Remote will not function if batteries are not installed correctly.
3.Slide remote cover back into place.
3 AAA Batteries
Cover
Remote
Control
OPERATING HEATER
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire de- partment.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
WARNING
•If fireplace has glass doors, never operate this heater with glass doors closed. If you operate heater with doors closed, heat buildup inside fire- place will cause glass to burst. Make sure there are no obstructions across opening of fireplace.
•You must operate this heater with a fireplace screen in place. Make sure fireplace screen is closed before running heater.
NOTICE: During initial operation of new heater, burn- ing logs will give off a
Figure 33 - Installing Batteries in Remote Control
For more
visit www.
.com
