OPERATING FIREPLACE
Continued
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: The receiver and
1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Slide the selector switch to the REMOTE position. Note: The burner may light if
IMPORTANT: Do not leave the selector switch in the RE- MOTE or ON position when the pilot is not lit. This will drain the battery.
2.Press the control button on the
3.To Lock press both buttons on remote control until light stops flashing. Remote is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.
4.To Unlock press both buttons together on remote control until light stops flashing. The remote is now unlocked.
Control Button
Turns Burners
On and Off
Figure 41 - On/Off Hand-Held Remote Control Unit GHRCB
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
Press in and turn control knob clockwise Clockwise
to the OFF position.
Shutting Off Burner Only (pilot stays lit)
Turn remote control wall switch to the OFF position.
OPERATING FIREPLACE | 19 |
Optional | |
To Turn Off Gas to Appliance |
|
INSPECTING BURNERS |
|
Pilot Assembly |
|
Burner Flame Pattern |
|
|
|
INSPECTING BURNERS
Check pilot flame pattern and burner flame patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper flame height. Alterations may have occurred during shipping and handling. The pilot is located on the back right hand side of the burner.
The height of the thermopile must be 3/8" to 1/2" above the pilot flame. The flame from the pilot burner must extend beyond the thermopile.
If your pilot assembly does not meet these requirements:
•Turn the adjustment screw marked pilot clockwise to decrease or counterclockwise to increase the flame to proper size (see Figure 39, page 18). Do not remove the adjustment screw.
•see Troubleshooting, pages 21 through 23
Thermopile
Pilot Burner
Ignitor
Figure 42 - Correct Pilot Flame Pattern
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or floating. Flames should go up through the middle of logset. Flames should not "spill" to the edges of the pan or sides of the logset.
Figure 43 shows a typical flame pattern. If burner flame pattern differs from that described:
•turn appliance off (see To Turn Off Gas to Appliance, column 1)
•see Troubleshooting, pages 21 through 23
Figure 43 - Typical Flame Pattern
For more information, visit www.desatech.com
