4
GAS CONTROL VALVE CONVERSION
Convert the gas control valve by swapping out the valve regulator portion of the gas valve.
1.Using a Torx T20 or slotted screwdriver, remove and discard the three mounting screws, pressure regulator tower, and dia- phragm/spring components (see Figure 8).
2.Insure that the rubber gasket is properly positioned on the new pressure regulator assembly. Install the LP pressure regulator assembly to the valve using the new mounting screws sup- plied with the kit. Tighten screws securely (approximately 25
3.Install the identification label enclosed with the gas valve regula- tor to the valve body where it can easily be seen (see Figure 9).
Mounting Screws 
LO
HI
Pressure
Regulator Tower
LO
HI
Mounting Screws
OFF
NO TOLPI
Rubber
Gasket
Identification Label
Diaphragm/Spring Components
Figure 9 - Installing Pressure Regulator Assembly
OFF
NO TOLIP
Figure 8 - Removing Mounting Screws, Pressure Regulator
Tower, and Diaphragm/Spring Components
For
.
.com
