OPERATION
Continued
STORING,
TRANSPORTING, OR SHIPPING
PREVENTATIVE MAINTENANCE SCHEDULE
6
5.Plug extension cord into standard 120 volt/60 hertz,
Control
Reset Button 
Figure 3 - Flame-Out Control Reset Button
To Stop Heater
1. Unplug extension cord from outlet.
To Restart Heater
1.Wait two minutes after stopping heater.
2.Repeat steps under To Start Heater, page 6.
Note: If shipping, transport companies require fuel tanks to be empty.
1.Drain fuel tank.
Note: Some models have drain plug on underside of fuel tank. If so, remove drain plug to drain all fuel. If heater does not have drain plug, drain fuel through fuel cap opening. Be sure all fuel is removed.
2.Replace drain plug if provided.
3.If any debris is noted in old fuel, add 1 or 2 quarts of clean kerosene to tank, stir, and drain again. This will prevent excess debris from clogging filters during future use.
4.Replace fuel cap or drain plug. Properly dispose of old and dirty fuel. Check with local automotive service stations that recycle oil.
5.If storing, store heater in dry place. Make sure storage place is free of dust and corrosive fumes.
IMPORTANT: Do not store kerosene over summer months for use during next heating season. Using old fuel could damage heater.
!WARNING
Never service heater while it is plugged in, operating, or hot. Severe burns and electrical shock can occur.
Item | How Often | How To |
Fuel tank | Flush every | See Storing, Transporting, or |
| of operation or as needed. | Shipping, above. |
Air output and | Replace every 500 hours of | See Air Output, Air Intake, |
lint filters | operation or once a year. | and Lint Filters, page 9. |
Air intake | Wash and dry with soap and | See Air Output, Air Intake, |
filter | water every 500 hours of op- | and Lint Filters, page 9. |
| eration or replace as needed. |
|
102437
