Desa RCCP80V owner manual Installation, Operation, To Start Heater

4

INSTALLATION OPERATION

To Start Heater

INSTALLATION

WARNING: Review and understand the warnings in the Safety Information section, page 2. They are needed to safely operate this heater. Follow all local codes when using this heater.

WARNING: Test all gas piping and connections for leaks after installation or servicing. Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once.

1.Provide propane supply system (see Propane Supply, page 3).

2.Connect fuel gas fitting on hose/regulator assembly to pro- pane tank(s). Turn fuel gas fitting counterclockwise into threads on tank. Tighten firmly using a wrench. IMPORTANT: Tighten regulator with vent pointing down (see Figure 3). Pointing vent down protects regulator from weather damage.

3.Connect hose to the valve inlet. Tighten firmly using wrench. You must use the regulator supplied with heater.

4.Open propane supply valve on propane tank(s) slowly. Note: if not opened slowly, excess-flow check valve on propane tank may stop gas flow. If this happens, you may hear a click inside the regulator assembly, this is the check valve closing. To re- set the excess-flow check valve, close propane supply valve and open it again slowly.

5.Check all connections for leaks. Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak that must be corrected.

6.Close propane supply valve.

	Fuel Gas Fitting
Propane
Supply Valve	Hose
	Regulator
	Vent
	(pointing down)

Valve Inlet

OFF
LO	HI
MED

Hose

Figure 3 - Hose and Valve Inlet

OPERATION

WARNING: Review and understand the warnings in the Safety Information section, page 2. They are needed to safely operate this heater. Follow all local codes when using this heater.

TO START HEATER

1.Follow all installation, ventilation, and safety information.

2.Locate heater on stable and level surface. Make sure strong drafts do not blow on heater.

3.Make sure unit is turned off by slightly depressing and turning control knob fully clockwise to "OFF".

4.Open propane supply valve on propane tank(s) slowly. Note: If not opened slowly, excess-flow check valve on pro- pane tank may stop gas flow. If this happens, you may hear a click inside the regulator assembly, this is the check valve clos- ing. To reset the excess-flow check valve, close propane sup- ply valve and open it again slowly.

5.Slightly depress and turn control knob counterclockwise to the low position (see Figure 4).

6.With the control knob pushed all the way in, press and release the peizo ignitor button. Keep pressing piezo ignitor button until the burner lights. Hold control knob down for a maxi- mum of 15 seconds while attempting ignition. If heater does not ignite, release control knob and wait 3 minutes before at- tempting reignition.

Propane Tank

Figure 2 - Regulator With Vent Pointing Down

Continue Turning Knob

Counterclockwise to

MED and HI

Piezo Ignitor Button

Off Low

Position Position

		OF	F
			OF	HI
LO		F
M	ED	HI	LO	ED
				M

OFF
LO	HI
MED

Control Knob

Figure 4 - Control Knob, and Piezo Ignitor Button Locations

For morevisit www..com

104781-01D