4 | LOCAL CODES |
PRODUCT FEATURES | |
| PROPANE/LP SUPPLY |
| INSTALLATION |
| Check Gas Type |
| Locating Heater |
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of National Fuel Gas Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent- free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
PROPANE/LP SUPPLY
Propane/LP gas and propane/LP tank(s) are to be furnished by the user. The propane/LP cylinder to be used must be constructed and marked in accordance with the specifications for the propane/LP gas cylin- ders of the U.S. Department of Transportation (DOT).
Use this heater only with a propane/LP vapor withdrawal supply system. See Chapter 5 of the Standard for Storage and Handling of Liquefied Petroleum Gas, ANSI/NFPA 58 and/or CAN/CGA B149.2. Your local library or fire department will have this booklet.
The amount of propane/LP gas ready for use from propane/LP tanks varies. Two factors decide this amount:
1.The amount of propane/LP gas in tank(s)
2.The temperature of tank(s)
This heater is designed for use with a 20 or 40 pound refillable propane/LP cylinder when used as a self contained heating system (with hose and regulator). Larger tanks may be used if installed in a permanent gas supply system.
The propane/LP cylinder used must include a collar to protect the cylinder valve, and a listed overfilling prevention device (OPD).
INSTALLATION
CHECK GAS TYPE
Use only propane/LP gas. If your gas supply is not propane/LP, do not install heater. Call dealer where you bought heater for proper type heater.
LOCATING HEATER
WARNING: Maintain the minimum clearances shown in Figure 2. If you can, provide greater clear- ances from floor, ceiling, and joining wall.
WARNING: Never install the heater
•in a bathroom
•where curtains, furniture, clothing, or other flam- mable objects are less than 36 inches from the front, top, or sides of the heater
•as a fireplace insert
•in high traffic areas
•in windy or drafty areas
CAUTION: This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities (such as, but not limited to, tobacco smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may discolor walls or cause odors.
CAUTION: If you install the heater in a home garage
•heater pilot and burner must be at least 18 inches above floor
•locate heater where moving vehicle will not hit it
For convenience and efficiency, install heater
•where there is easy access for operation, inspection, and service
•in coldest part of room
CEILING
36"
Minimum
6" Minimum
From 
Sides Of
Heater
Right
LeftSide
Side
3" Minimum To Top Surface
Of Carpeting, Tile Or Other
FLOOR Combustible Material
Figure 2 - Mounting Clearances As Viewed From Front of Heater
For
.
.com
