Safety Information, Product Identification, Unpacking, Continued

SAFETY INFORMATION

Continued

7.Use only in well-vented areas. Before using heater, provide at least a three-square-foot opening of fresh, outside air for each 100,000 Btu/Hr (105,500 k/j) of rating.

8.Do not use heater outdoors or in occupied dwellings.

9.Do not use heater in living or sleeping quarters.

10.Keep appliance area clear and free from com- bustible materials, gasoline, paint thinner and other ﬂammable vapors and liquids. Dust is combustible. Do not use heater in areas with high dust content.

11.This heater is equipped with a thermostat. Heater may start at anytime.

12.Check heater for damage before each use. Do not use a damaged heater.

13.Use only propane/LP gas set up for vapor withdrawal.

14.Keep propane tank(s) below 100° F (38° C).

15.Do not use heater in a basement or below ground level. Propane/LP gas is heavier than air. If a leak occurs, propane/LP gas will sink to the lowest possible level.

16.Use only the hose and factory regulator pro- vided with the heater.

17.Check hose before each use of heater. If highly worn or cut, replace with hose speciﬁed by manufacturer before using heater.

18.Do not alter heater. Keep heater in its original state.

19.Do not use heater if altered.

20.Keep heater at least 6 feet (1.8 m) from propane/LP tank(s). Do not point heater at propane/LP tank(s) within 20 feet (6.1 m).

21.Minimum heater clearances from combus- tibles: Outlet: 8 Ft. (2.4 m), Sides: 2 Ft. (0.6 m), Top: 6 Ft. (1.8 m), Rear: 2 Ft. (0.6 m)

22.Locate heater on stable and level surface if heater is hot or running.

23.Keep children and animals away from heater.

24.Turn off propane/LP supply and unplug heater when not in use.

25.Never block air inlet (rear) or air outlet (front) of heater.

26.Never move, handle or service a hot, operating or plugged-in heater.

27.Never attach duct work to front or rear of heater.

28.Use only original replacement parts. This heater must use design-specific parts. Do not substitute or use generic parts. Improper replacement parts could cause serious or fatal injuries.

29.Do not adjust regulator below 7 psig or above 20 psig.

PRODUCT

IDENTIFICATION

Hot Air Outlet (Front)

Handle

Fan

Guard

Outer

Shell

On/Off

Switch

Inlet Connector

Power Cord

Hose/Regulator

Assembly

REAR VIEW

Thermostat Knob

Figure 1 - 375,000 Btu/Hr Models

UNPACKING

1.Remove all packing items applied to heater for shipment. Keep plastic cover cap (attached to inlet connector and hose/regulator assembly) for storage.

2.Remove all items from carton.

3.Check all items for shipping damage. If heater is damaged, promptly inform dealer where you bought heater.

116699-01B

Desa 375-F, SBLP375AT Safety Information, Product Identification, Unpacking, Continued, Rear View

Models: 375-F SBLP375AT