SERVICE PROCEDURES
Continued
15.Replace fan on motor shaft. Make sure set- screw is touching back of flat surface on motor shaft (see Figure 9).
16.Place setscrew on flat of shaft. Tighten set- screw firmly
17.Remove two nuts and bolts securing motor mount to shell.
18.Pull motor and fan from shell. Turn motor and fan around. Carefully place back in shell. Note: Fan will go into shell first.
19.Line up mounting holes in shell with holes on motor mount. Replace four bolts through shell and motor mount. Insert bolts from outside of heater. Tighten nuts firmly.
20.Route motor wires through hole in bottom of shell (see Figure 6, page 7).
21.Connect motor wires as follows (see Figure 5, page 7):
•white
Note: Attach to empty connector on white wire side of terminal board
•black
Note: Attach to empty connector on black wire side of terminal board
•blue
•orange
•green
22.Replace side cover.
23.Replace fan guard.
| Fan |
Hub | Motor |
| Shaft |
| Setscrew |
Figure 9 - Fan Cross Section | |
SERVICE PUBLICATIONS | |
You can receive an Illustrated Parts List free of | |
charge. Send your request and a | |
stamped envelope to DESA Heating Products | |
(address on back page). Be sure to include the | |
heater model number. You can purchase a service | |
manual for $5. Make check payable to DESA | |
Heating Products. |
|
SPECIFICATIONS
•Output Rating - 225,000 to 375,000 (Btu/Hr)
•Fuel - Propane/LP Vapor Only
•Fuel Consumption
Gallons(liters)/Hour - 2.5 (9,4) Min/4.0 (15) Max Pounds(kg)/Hour - 10.4 (4.7) Min/17.4 (7.9) Max
•Supply Pressure To Regulator Minimum* - 25 psig (172 kPa) Maximum - Tank Pressure
•Regulator Outlet Pressure -
•Hot Air Output - 1500 CFM (pi³/min)
•Motor - 1725 RPM, 1/5 HP
•Electric Input - 120 V/60 Hz
•Amperage - 4.2
•Ignition - Electronic Direct Spark, D.S.I.
* (for purposes of input adjustment)
ACCESSORIES
Purchase accessories and parts from your nearest dealer or service center. If your dealer or service center can not supply an accessory or part, either contact your nearest Parts Central (listed in the separate Authorized Service Center booklet) or call DESA Heating Products at
Fuel Gas Connector: LPA4020
A POL adapter with
Thermostat: HA1210
TECHNICAL SERVICE
You may have further questions about installation, operation or troubleshooting. If so, contact DESA Heating Productsʼ Technical Service Department at
You can also visit DESA Heating Productsʼtechni- cal services web site at www.desatech.com.
8 | www.desatech.com |