Desa SCIVFB, SCIVFR, SCIVFG, SCIVFC Installing, Continued, Set top grate into stove top

INSTALLING

Continued

10.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Figure 8 and 11). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.

Stove	Stove
	Door
Door

Door

Hinge

Step

Bolt

Bolt

Shoulder

Threaded	Bolt
Hole	Shoulder

Door

Hinge

Step

Bolt

Stove Bottom

Figure 11 - Attaching Stove Door

12

11.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 8, page 10). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

Bolt Stop

Adjusting Nut

Door Door Claw

Catch Bolt

Figure 12 - Catch Bolt and Door Claw Orientation

12.Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in normal standing position.

13.Carefully lift stove back up on its four attached legs.

14.Set top grate into stove top.

15.If available, install gas log heater inside stove cavity before installing the back panel (see Installing Gas Log Heater Into Stove page 13).

16.Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts and washers. Make sure product identification label is located on the outside in lower left-hand corner.

104025