INSTALLATION
Continued
CAUTION: Do not remove the data plates attached to the heater base assembly. The data plates contain important war- ranty and safety information.
WARNING:Failuretoposition thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
INSTALLING GAS LOG INTO STOVE
1.Remove log from carton.
2.Remove all protective packaging applied to log for shipment.
3.Check log for any shipping damage. If dam- aged (pieces larger than the size of a dime), promptly inform dealer where you bought heater.
4.Set
5.Fasten back panel to stove with four (4) M6 x 1bolts and washers.
6.Place freestanding stove in desired position in room. Be sure to maintain clearances to combustibles as outlined on page 8.
CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs according to the log installation instruc- tions in this manual. Flames con- tacting logs will create soot.
Log Set
Middle
Section at
Bottom of
Log Set
Heater Base | Burner |
|
"U" Shaped
Cutout in Chassis
Figure 12 - Installing One-Piece Stove
Log Set
Burner Porting Areas (double slotted rectangular openings)
Log Set
Safety Pilot Location
Figure 13 - Top View of One-Piece Log
Set on Gas Log Heater
CONNECTING TO GAS SUPPLY
WARNING: This appliance requires a 1/2" NPT (National Pipe Thread) inlet connection to the pressure regulator.
WARNING:Aqualifiedservice person must connect heater to gassupply.Followalllocalcodes.
CAUTION: Never connect propane/LP heater directly to the propane/LP supply. This heater requires an external regulator (not supplied). Install the exter- nal regulator between the heater and propane/LP supply.
www.desatech.com | 11 |
