Safety

Continued

This is a propane, direct-fired heater. Propane is heavier than air. If propane leaks from a connection or fitting, it sinks to the floor, collecting there with the surrounding air, forming a potentially explosive mixture. Obviously, propane leaks should be avoided, so set up the propane supply with utmost care. Read Propane/LP Safety, page 4 for additional information about detecting propane leaks. Leak check new connections or reconnections with a soap and water solution and follow all connection instructions herein. Also, ask your propane dealer for advice on the propane application and supply installation and ask them to check it if there are any questions.

When the heater is to be operated in the presence of other people the user is responsible for properly acquainting those present with the safety precautions and instructions, and of the hazards involved.

Make certain you read and understand all warnings. Keep this manual for reference. It is your guide to safe and proper operation of this heater.

1.Check heater thoroughly for damage. DO NOT operate a damaged heater.

2.DO NOT modify heater or operate a heater which has been modified from its original condition.

3.Use only propane/LP gas.

4.Use 20 lb. propane/LP tank or larger.

5.Use only VAPOR WITHDRAWAL pro- pane supply. The propane cylinder must be arranged for vapor withdrawal, in accordance with the Compress Gas As- sociations, Small Propane Bottle Assem- bly. If there is any question about vapor withdrawal, ask your propane dealer.

6.Always fully assemble heater before each use. Do not use this heater without securing fuel tank as instructed. Minimum clearance from fuel tank to ground is 2".

7.Use only hose and regulator assembly provided with heater.

8.Inspect hose assembly before each use of heater. If there is excessive abrasion or wear, or hose is cut, replace with hose assembly listed on parts list before using heater.

9.This heater is for OUTDOOR USE ONLY, even so, make sure that there is ample fresh air ventilation. Do not use in build- ings, garages or other enclosed spaces.

10.If at any time gas odor is detected, IM- MEDIATELY DISCONTINUE operation until source of gas has been located and corrected. Read Propane/LP Safety, page 4 for additional information about detect- ing propane leaks.

11.Install heater such that it is not directly exposed to water spray, rain and/or drip- ping water.

12.Maintain minimum clearance to people or normal combustible material (like paper) of 18" (0.46 m) from top and 18" (0.46 m) from the reflector.

13.Operate only on a stable, level surface.

14.Do not spray aerosols near heater during use or shortly thereafter.

15.Do not clean heater with combustible or corrosive cleaners. Use warm, soapy water on external surfaces only. Do not submerge in water.

16.Check control compartment burners and circulation air passageways for free air passage, make sure that there are no obstructions. These areas are a com- mon location for spider webs, which can present a dangerous condition, damage the heater and render it unsafe for use. The heater must be checked if any of the following conditions exist:

a)Gas smell.

b)Heater does not reach temperature.

c)Uneven burner glow.

d)Burner makes popping noises during nor- mal use, other than during shutdown.

17.Use only soapy water (1 part liquid dish washing detergent to 3 parts water) to con- duct leak tests whenever a propane cylinder is connected. Bubbles indicate a leak.

18.Do not adjust gas regulator. If you are unsure of your appliances gas type or pressure, call a qualified service person.

19.Always disconnect gas supply after heater is turned OFF.

20.Do not move, handle or service while hot or burning.

21.Allow 45 minutes to cool down after use before attempting to move heater.

22.Do not operate this appliance in windy conditions. Maximum allowable wind speed is 10 mph (16 Km/h).

23.Do not operate this appliance in tempera- ture conditions below 40° F (5° C).

122139-01Awww.desatech.com