Assembly

1.Install threaded poles into triangular base as shown in Figure 1. Be sure to seat poles fully inside base.

2.Install lower legs by pressing push tab release and inserting into upper pole (see Figure 2). Be sure push button is locked in place.

3.Install 3 feet to lower legs as shown in

Figure 3. Be sure to tighten wing bolt after installation.

4.Install tank straps to propane/LP gas cylinder as shown in Figure 4. Length of strap from tank flange to end of clip should be between 9" and 10" from tank flange.

This should maintain a 2" minimum clear- ance from bottom of propane/LP tank to ground.

Wing Nut On

Inside of Foot

Figure 3 - Installing Feet to Lower PolesFigure 1 - Base and Pole Assembly

Push Tab

Release

Push Tab

Release in Hole

of Upper Pole

9"-10"

Figure 2 - Installing Lower Legs intoUpper PolesFigure 4 - Attaching Tank Straps

122139-01Awww.desatech.com