MODELS: VCBK4R &VCBK4L FAN KIT
INSTALLATION AND OPERATING INSTRUCTIONS
INSTALLING BLOWER BEFORE MOUNTING FIREPLACE
Note: Fireplace must be properly connected to a 110V power source before blower can be operated.
1.Remove large knockout tab (see Figure 1).
2.Align two holes on side of rectangular bracket with two holes on side frame. Secure with screws provided (see Figure 7).
3.Place blower assembly in fireplace and plug male electrical connector into female connector already in fireplace. Make sure
rocker switch wire protrudes through notch in fireplace side (see Figure 2). Connect wires with rocker switch.
4.Take four sheet metal screws provided and secure blower as- sembly to fireplace through holes (see Figure 3). Blower should now be in place and look similar to Figure 4.
Note See instructions on reverse side if FULL VIEW glass doors are installed.
Fireplace
Fireplace | Blower |
| |
| Assembly |
Knockout Tab
Electrical Connection
| Rocker Switch | Male Electrical |
| and Wiring | |
| Connector | |
|
| |
Figure 1 |
| Figure 2 |
| Blower |
|
| Assembly |
|
Sheet Metal
Screws
Rectangular
Bracket
ON/OFF Switch 
Fireplace Face
Figure 3 | Figure 4 |
