Heat & Glo LifeStyle 6000TRI-SP manual Installing the Optional Heat-Zone Kit, Gas Control Systems

Step 5. Installing the Optional Heat-Zone Kit

NOTE: There must be NO INSULATION or other com- bustibles inside the framed firestop opening.

HEAT-ZONE

ATTACHES

HERE

Figure 32.

1.Remove the knockout from the fireplace and discard it (see Figure 32).

2.Center the duct collar around the exposed hole and at- tach it to the fireplace with 3 screws. NOTE: Do this BE- FORE final positioning of the fireplace.

3.Determine the location for the air register/fan housing assembly.

Reference the Heat-Zone kit instructions for the remaining installation steps.

Step 6. The Gas Control Systems

!WARNING: THIS UNIT IS NOT FOR USE WITH SOLID FUEL.

The types of gas control systems used with this model are Intermittent Pilot Ignition (IPI) and Standing Pilot Ignition (SP).

Intermittent Pilot Ignition (IPI) System

This system includes a 3V control valve, electronic module and intermittent pilot.

!WARNING: CONTINUOUS 110-120 VAC SER-

VICE MUST BE WIRED DIRECTLY TO THE FIRE- PLACE JUNCTION BOX.

FLAME SENSOR

ROD

Figure 33. Gas Control System (IPI)

Standing Pilot Ignition System

This system includes millivolt control valve, standing pilot, thermopile/thermocouple flame sensor, and piezo ignitor.

WARNING: 110-120 VAC MUST NEVER BE ! CONNECTED TO A CONTROL VALVE IN A

MILLIVOLT SYSTEM.

Figure 34. Gas Control System (Standing Pilot)

Heat & Glo • 6000TRI-IPI, 6000TRI-SP • 385-901 Rev. F • 5/05 27