Heat & Glo LifeStyle 6000TRI-IPI, 6000TRI-SP manual Reinstall the Exhaust Shield

3.Match the amount of vertical you have in the sys- tem with the chart to find the appropriate position to set the Flue Restrictor (see Figure 9).

- CHART -

Vertical	Top Vent	Top Vent	Rear Vent	Rear Vent
	NG	LP	NG	LP
4'	1-1	No	No	No
		Restrictor	Restrictor	Restrictor
8'	2-2	1-2	1-1	No
				Restrictor
15'	3-3	3-2	2-2	1-2
20'	3-4	3-3	3-3	2-3
25'	3-4	3-3	3-3	2-3
30'	4-4	3-4	3-4	3-3
35'	4-4	3-4	3-4	3-3
40'	5-4	4-4	4-4	3-4

Figure 9

4. Center the Flue Restrictor on vent and secure in place by using two self-tapping screws.

5. Reinstall the Exhaust Shield.

1 2 3 4 5

SETTINGS

1 2 3 4 5

Figure 10

HORIZONTAL VENTING

Kit No.	H Max. Run
DVP-TRAP	24" (610 mm)

H

90-DEGREE ELBOWS

45-DEGREE

ELBOW

NOTE: This model is tested and approved to use 45° elbows in corner installations. However, 90° elbows will result in better performance. The use of two 900 elbows in a corner installation will affect space requirements (see Figure 2).

Figure 11. Corner Installation

16 Heat & Glo • 6000TRI-IPI, 6000TRI-SP • 385-901 Rev. F • 5/05