INSTALLING BLOWER AFTER MOUNTING THE FIREPLACE
Note: Fireplace must be properly connected to a 110V power source before blowers can be operated.
1.Remove three screws that secure side brick retainers. Pull out side brick exposing blower cover plate on right side of fireplace
(see Figure 5).
2.Remove blower cover plate (see Figure 6).
3.Place blower assembly through hole in firebox. Make sure wire protrudes through notch in fireplace side. Align two holes on side of rectangular bracket with two holes on side frame. Secure with screws provided (see Figure 7). Blower assembly should now look similar to Figure 8.
4.Before replacing blower cover plate, plug male electrical connec- tor on blower assembly into female socket already in fireplace. Replace blower cover plate, side brick and retainer before using fireplace.
Side Brick 
Fan
Cover
Plate 
Knockout
Plate
Side Brick
Retainer
Figure 5 | Figure 6 |
Firebox | Fireplace | |
Side | ||
| ||
Fan Assembly | Rectangular | |
Bracket | ||
| ||
| Rectangular | |
| Bracket | |
ON/OFF |
| |
Switch Wiring | ON/OFF Switch |
Fireplace Face
Figure 7 | Figure 8 |
SPECIAL INSTRUCTIONS FOR GLASS DOORS
If doors are installed, it is necessary to remove the right door and side frame. To remove door, press upper hinge spring in door track and slide track and slide door assembly to the left. To remove side door frame, remove top and lower most hex head screws securing frame.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 2701 Industrial Drive |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| P.O. Box 90004 | 56105 |
56105 |
|
|
|
|
|
|
|
| Bowling Green, KY | Rev. C | ||||||
NOT A UPC |
|
|
|
|
|
|
| For more information, visit www.desatech.com | 01/06 | |||||||
|
|
|
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
