Desa VDCFTNB Optional HAND-HELD Remote Operation, Thermostat Series Model HRC200, Manual Mode

OPERATING FIREPLACE

Continued

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 40). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 23.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 41). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand- held remote control unit.

IMPORTANT:Do not leave the selectorswitch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

FlameControl

Adjustment Knob Knob

Indicator	Control
	Button
Light

Figure 42 - ON/OFF Hand-Held Remote Control Unit

THERMOSTAT SERIES (MODEL HRC200)

The hand-held remote can be operated using either the manual mode (MANU) or thermo- static mode (AUTO) (see Figure 43). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

Indicator	Digital Display Shows
Light	Temperature and Settings
Locks		AUTO
	ROOM		SET
System to	TEMP		TEMP
Prevent	LOCK		POWER
Accidental		TEMP
Ignition

Selector Switch in Remote Position (Optional Remote Control)

Figure 41 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

ON/OFF SERIES (MODEL HRC100)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 42).

To Lock press both buttons on hand-held

Turns Burners On or Off

Increases or Decreases Room Temperature in AUTO Mode

MANU ºC/ºF AUTO

		Turns
		Hand-Held
		Remote On
		or Off and
°C/°F		Allows You
	Selects	to Choose
Mode		the Manual
	AUTO
Button		Setting
	Mode

remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

Figure 43 - Thermostat Hand-Held Remote Control Unit

Manual Mode

1.Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2.Press the MANU button to turn on the fireplace.

3.Press the POWER and LOCK buttons together to turn off the fireplace.

116526-01A www.desatech.com 25