TROUBLESHOOTING
Continued
OBSERVED PROBLEM POSSIBLE CAUSE | REMEDY |
ODS/pilot lights but flame goes out when control knob is released
1.Control knob not fully pressed in
2.Control knob not pressed in long enough
3.Safety interlock system has been triggered
4.Equipment shutoff valve not fully open
5.Pilot flame not touching ther- mocouple, which allows ther- mocouple to cool, causing pilot flame to go out. This problem could be caused by one or both of the following:
A)Low gas pressure
B)Dirty or partially clogged ODS/pilot
6.Thermocouple connection loose at control valve
7.Thermocouple damaged
8.Control valve damaged
1.Press in control knob fully
2.After ODS/pilot lights, keep control knob pressed in 30 seconds
3.Wait one minute for safety in- terlock system to reset. Repeat ignition operation
4.Fully open equipment shutoff valve
5.A) Contact local natural or propane/LP gas company
B)Clean ODS/pilot (see Cleaning and Maintenance, page 27) or replace ODS/pilot assembly
6.Hand tighten until snug, then tighten 1/4 turn more
7.Replace pilot assembly
8.Replace control valve
Burner does not light after 1. Inlet gas pressure is too low
ODS/pilot is lit |
|
2. | Burner orifice is clogged |
3. | Thermopile leads disconnected |
| or improperly connected (Re- |
|
|
4. | Burners will not come on in re- |
| mote position |
| Models Only) |
1.Contact local natural or pro- pane/LP gas company
2.Clean burner (see Cleaning and Maintenance, page 27) or replace burner orifice
3.Reconnect leads (see Wiring Diagram, page 28)
4.Replace battery in transmitter and receiver
Delayed ignition of burner | 1. Manifold pressure is too low | 1. | Contact local natural or pro- | ||
|
|
|
|
| pane/LP gas company |
|
| 2. | Burner orifice is clogged | 2. | Clean burner (see Cleaning |
|
|
|
|
| and Maintenance, page 27) |
|
|
|
|
| or replace burner orifice |
|
|
|
|
| |
Burner backfiring during com- | 1. Burner orifice is clogged or | 1. | Clean burner (see Cleaning | ||
bustion |
| damaged |
| and Maintenance, page 27) | |
|
|
|
|
| or replace burner orifice |
|
| 2. | Damaged burner | 2. | Replace damaged burner |
|
| 3. | Gas regulator defective | 3. | Replace gas regulator |
|
| 4. | Inlet gas pressure is too low | 4. | Contact local natural or pro- |
|
|
|
|
| pane/LP gas company |
30 | www.desatech.com |
