CLEANING AND
MAINTENANCE
WARNING: Always discon- nect power and allow the heater to cool before performing any cleaning, maintenance or reloca- tion of this heater. Turn controls to OFF and remove plug from outlet or turn off circuit breaker to heater.
Turn off heater and circuit breaker to heater before performing any cleaning and/or maintenance. Al- low heater to cool completely.
BULB REPLACEMENT
WARNING: The halogen light bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning off the heater and removing the light bulbs to avoid accidental burns.
There are a total of 7 ( halogen light bulbs (type GX6.35 rated 120 volts, 35 watts) in your unit.
•2 bulbs provide illumination for the ember bed beneath the log set
•2 bulbs provide illumination for the flame generation assembly
•1 bulb provides illumination for the top con- trasting light
•2 bulbs for replacement
Most halogen light bulbs are rated to last approxi- mately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your unit have burned out you will notice or more of the following:
•Contrasting light is dark
•Flame is dim or dark in certain areas
•Log set ember bed appears dim or dark in certain areas
WARNING: Do not install replacement bulbs that exceed specified maximum watts.
Your unit must be opened in order to replace the light bulbs. To reduce the number of times you need to open the unit, replace all bulbs at the same time.
Removing Top of Unit
1.Unplug unit from the power supply.
2.Remove the two screws at the rear of the unit which secure the top to the back frame.
3.Two clips hold the top to the sides. Push the top of the unit toward the back until the clips disconnect. Remove top of the unit and place face up on the floor.
4.Unscrew the 4 screws from the metal plate and set plate aside.
Figure 5 - Stove Top Removal
Replacing Top Contrasting Bulb
1.The housing for the top contrasting light is connected to the top of the mirror. Remove housing from mirror by gently lifting up.
CAUTION: Do not force the light housing off the mirror. This may damage the mirror (e.g. chipping, cracking, etc.)
2.Remove screws from each side of housing.
3.Carefully reach into the housing and remove spring clip. Hold socket and pull out the old bulb.
3.Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip.
4.Set aside until all bulbs have been changed.
Front of Stove
Screw | Housing | Mirror |
| ||
|
|
Figure 6 - Removing Housing and Top
Contrasting Bulb
6 | www.desatech.com |
