GROUNDING
INSTRUCTIONS
This stove is for use on 120 volts. The cord has a plug as shown in Figure 2. An adapter is available for connecting
Grounding Pin | Adapter |
Figure 2 - Grounding Methods
OPERATING
INSTRUCTIONS
Once the unit has been properly connected to a ground electrical outlet, it is ready to operate. Note: Ensure the circuit breakers for power supply are turned on.
CONTROL PANEL OPERATION
Controls are located on the back of the unit (see Figure 3).
1.Main ON/OFF power switch: This switch is located at the furthest right corner on the control panel when looking at the back of the unit. Turn the switch to ON and unit will be ready to operate. The "" indicates ON and "O" indicates OFF.
IMPORTANT: Once you turn the main switch to the ON posi- tion, the remote control can no longer be used. In order to use the remote control, you must keep the main ON/OFF switch in the OFF.
2.Display ON/OFF Dial: There is a flame icon directly below this dial and it is the knob at. After you turn the Main Power switch to the ON position, turn the Display Dial to desired setting. Both the logset and the flame will light up inside the fireplace
3.Heater Switch and Control Dial: The heater switch has a sun directly below it. To turn the heateron, flipthe HeaterSwitch to ON position (the "" indicates ON and "O" indicates OFF). The Control Knob has a thermometer below it. Turn the dial clockwise past the number 8. You should heara small clicking sound indicat- ing the heater has started and heat will emit through vents located at the bottom of the unit. To turn off heater, turn the temperature dial counter clockwise past number 1 and flip the Heater Switch to OFF position. Heat will stop coming out of the vent.
To increase the desired temperature, turn the temperature dial clockwise towards Number 8.
To decrease the desired temperature, turn the temperature dial counter clockwise towards number 1. The heater has a
Note: When the heater is turned on for the first time, it may release a slight, harmless odor. This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again.
4.Flame Control Dial: This dial controls the intensity of the flame.
Flame Control Dial Main Power Switch
Heater Switch |
|
Display Dial | Heat Control Dial |
Figure 3 - Electric Stove Control Panel
OPERATING BY REMOTE CONTROL
1.Plug in your electric fireplace and it will beep once. This means you have power and your remote is ready to operate your electric fireplace.
IMPORTANT: To control the electric fireplace by remote, the Main ON/OFF power switch on the fireplace must be in the OFF position; the remote control will NOT work if the manual ON/OFF switch is in the ON position.
4 | www.desatech.com |
