CLEANING AND
MAINTENANCE
Continued
Replacing Log Set Ember Bed Bulbs
1.Carefully remove mirror from unit by lift- ing it gently from the stove. Store in a safe place or lay it face down on the carpet.
2.From the bottom, lift up the log set ember bed and remove it from the unit (do not pull up on logs).
3.Remove spring clip from bulb. Hold socket and pull out old bulb.
4.Hold socket and push in new bulb. Replace spring clip.
5.Repeat steps 2 and 3 for the second bulb.
| Bulb with |
Bulb with | Spring Clip |
| |
Spring Clip |
|
Log Grate
Figure 7 - Ember Bed Bulb Replacement
(Looking in from Top of Unit)
Replacing Flame Generation Bulbs
1.Unscrew the 6 screws from back of stove shown in Figure 8. Remove metal plate.
AVOID STRESS TO THE WIRES.
| Grounding | |
| Connecting Screw | |
Screws | Screws | Screws |
Figure 8 - Locating Flame Generation
Cylinder
2.Locate the flame generation cylindrical drum. It is constructed of two removable halves; ei- ther of which can be removed from the unit.
2.Squeeze half of drum cylinder until it's top edge clears the top drum track. Remove bot- tom edge of cylinder drum from bottom drum track. This will give you access to the light bulbs. Note: Do not exert excessive pressure on drum cylinder as this may cause damage.
3.Remove spring clip. Hold socket and pull out old bulb.
4.Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip.
5.Repeat steps 5 and 6 for second bulb.
6.Insert bottom edge of removed cylinder half into bottom drum track. Gently squeeze drum cylin- der until it's top edge fits into top drum rack.
7.Replace the metal plate with screws.
8.Replace the log set ember bed.
9.Replace the mirror. Note: Before replacing, clean mirror of any dust or fingerprints. Make sure the mirror side is toward the front of the unit.
10.Replace the top contrasting light housing. Note: The contrasting light should be placed at the mid point of the mirror edge.
11.Replace the metal plate and 4 screws. Replace the top of the unit by sliding the top forward until the clips reconnect.
12.Secure the top to the back frame by reattach- ing screws.
Flame Cylinder Drum
Figure 9 - Flame Generation Cylinder Drum
www.desatech.com | 7 |
