Grounding
instructions
This stove is for use on 120 volts. The cord has a plug as shown in Figure 2. An adapter is available for connecting
Grounding Pin | Adapter |
Figure 2 - Grounding Methods
Operating
Instructions
Once the unit has been properly connected to a ground electrical outlet, it is ready to operate. Note: Ensure the circuit breakers for power supply are turned on.
Control Panel Operation
Controls are located on the back of the unit (see Figure 3).
1.Main ON/OFF Power Switch: This switch is located at the furthest right corner on the control panel when looking at the back of the unit. Turn the switch to ON and unit will be ready to operate. The "" indicates ON and "O" indicates OFF.
IMPORTANT: Once you turn the main switch to the ON posi- tion, the remote control can no longer be used. In order to use the remote control, you must keep the main ON/OFF switch in the OFF.
2.Ember Control Dial: There is a divided circle under this dial. After you turn the Main Power switch to the ON position, turn the Ember Control Dial to desired setting. This dial controls the intensity of the light- ing under the ember bed.
3.Flame Control Dial: There is a flame picture under this dial. Turn this dial to adjust the flame intensity.
4.Heater Switch and Control Dial: The heater switch has a sun directly below it. To turn the heater on, flip Heater Switch to ON position
( "" indicates ON and "O" indicates OFF). The Control Dial has a thermometer below it. Turn dial clockwise past the number 8. You should hear a small clicking sound indicat- ing the heater has started and heat will emit through vents located at the top of unit.To turn off heater, turn the temperature dial counter clockwise past number 1 and flip Heater Switch to OFF position.
To increase the desired temperature, turn temperature dial clockwise towards Num- ber 8.
To decrease desired temperature, turn temperature dial counter clockwise towards number 1. The heater has a
Note: When the heater is turned on for the first time, it may release a slight, harmless odor. This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again. (Some odor may occur when dust settles on the unit and is burned off).
Heater Switch | Main Power Switch |
Heat Control | Flame |
|
Ember Control | ||
Dial | Control Dial | Dial |
Figure 3 - Electric Stove Control Panel
Operating by remote control
1.Plug in your electric fireplace and it will beep once. This means you have power and your remote is ready to operate your electric fireplace.
IMPORTANT: To control the electric fireplace by remote, the Main ON/OFF power switch on the fireplace must be in the OFF position; the remote control will NOT work if the manual ON/OFF switch is in the ON position.
www.desatech.com119668-01A
