Desa VESBMRA, CGESBMRA operation manual Cleaning and Maintenance

Models: CGESBMRA VESBMRA

1 12
Download 12 pages 61.25 Kb
Page 6
Image 6
Cleaning and

Cleaning and

Maintenance

Manual background WARNING: Always discon- nect power and allow the heater to cool before performing any cleaning, maintenance or reloca- tion of this heater. Turn controls to OFF and remove plug from outlet or turn off circuit breaker to heater.

Turn off heater and circuit breaker to heater before performing any cleaning and/or maintenance. Al- low heater to cool completely.

Bulb Replacement

Manual background WARNING: The halogen light bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning off the heater and removing the light bulbs to avoid accidental burns.

There are a total of 5 ( halogen light bulbs (type GX6.35 rated 120 volts, 35 watts) in your unit.

1 bulb provides illumination for the ember bed beneath the log set

2 bulbs provide illumination for the flame generation assembly

2 bulbs for replacement

Most halogen light bulbs are rated to last approxi- mately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your unit have burned out you will notice one or more of the following:

Flame is dim or dark in certain areas

Log set ember bed appears dim or dark in certain areas

Manual background WARNING: Do not install replacement bulbs that exceed specified maximum watts.

Your unit must be opened from the back in order to replace the flame generation bulbs. To replace the bulb under the ember bed you will open the unit in front.

Replacing Log Set Ember Bed Bulb 1. Turn knob and open door of stove.

2. Push in and up on lower front panel. The panel slides into notches on front sides of stove as shown in Figure 5.

3. Remove two screws securing grate. Remove grate.

4. Hold log up away from bulb and carefully remove spring clip over bulb using needle nose pliers. Remove bulb.

5. With log being held up away from socket, insert new bulb and carefully replace spring clip using needle nose pliers.

Log

Lower Front

Bulb in Socket

Panel

 

Grate

with Spring Clip

 

Figure 5 - Ember Bed Bulb Location

Replacing Flame Generation Bulbs

1. Unscrew 4 screws from louvered back panel (see Figure 6). Remove louvered back panel.

Back

Control

Panel Manual background

Louvered

Back

Panel Manual background

Lower

Back

Panel

Figure 6 - Back of Stove

www.desatech.com119668-01A

Page 6
Image 6
Desa VESBMRA, CGESBMRA operation manual Cleaning and Maintenance