U-Line 75F manual General Cleaning, Cleaning and Maintenance, Exterior Cleaning As Required

6 Cleaning and Maintenance

General Cleaning

Exterior Cleaning (As Required)

Black and White Models:

•Surfaces may be cleaned with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to prevent water spotting.

Interior Cleaning (As Required)

•Disconnect power to the unit. Clean the interior and all removed components using a mild non-abrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth. Rinse the interior using a soft sponge and clean water.

•Do not use any solvent-based or abrasive cleaners. These types of cleaners may transmit taste to the interior products and damage or discolor the interior.

Maintenance

Proper maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations.

Defrosting

Manual Defrost Models - Every Two Months (Minimum)

WARNING

DO NOT use any type of electrical heating device, ice pick, knife or other sharp instrument to defrost; this could damage the inner lining or refrigeration system and void the warranty.

ULIN_0231_A

Figure 4

To defrost:

1.Turn unit off.

2.Remove all products from the interior.

3.Remove all glass shelving from unit. Allow glass to acclimate to room temperature, then clean and set aside to reinstall after defrosting unit.

4.Prop the door in an open position (2" (5 cm) minimum).

5.Allow the frost to completely melt naturally. Clean the interior and all removed components using a mild non- abrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth. NOTE: DO NOT use any solvent-based or abrasive cleaners. They will discolor or damage the interior.

6.Dampen a soft sponge or non-abrasive cloth in clean water and wipe down the cabinet interior and removed components to remove any detergent residue. Rinse the sponge or cloth in clean water and repeat as necessary until the cabinet and components are clean.

7.When the interior is dry, reinstall glass shelving, making sure back strips are attached on back edge of glass fully. Then slide glass back into unit fully and turn unit back on.

8 75F