U-Line 75F manual Door Alignment Check and Adjustment, Door Reversal

2.If the unit is not level, adjust the feet on the corners of the unit as necessary (Figure 9).

3.Check the levelness after each adjustment and repeat the previous steps until the unit is level.

Door Alignment Check and Adjustment

IMPORTANT

Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to assure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door.

ULIN_0104_A

Figure 10

NOTE: It may be necessary to remove the grille to access lower hinge screws.

1.Loosen (do not remove) top (Figure 10) and bottom hinge screws.

2.Align door squarely with cabinet.

3.Make sure gasket is firmly in contact with cabinet all the way around the door (no gaps).

4.Tighten bottom hinge screws.

5.Tighten top hinge screws.

Door Reversal

To reverse the door, perform the following:

ULIN_0104_A

Figure 11

1.Remove grille unit.

2.Remove top hinge from cabinet (four screws) (Figure 11). Hold door to keep it from falling.

3.Lift the door off the bottom hinge.

ULIN_0105_A

Figure 12

4.Remove four plastic plugs (Figure 12) in hinge holes, top of cabinet, opposite side. Be careful not to scratch cabinet.

	Hinge
Plastic		Plastic
Plug Hole		Plug Hole
	Screw
Right Side		Left Side
Door Swing		Door Swing
Right Side	Invert	Invert
Hinge	Screw	Hinge
		ULIN_0106_A

Figure 13

10 75F