Operating Fireplace, Lighting Instructions

OPERATING FIREPLACE

For Your Safety Read Before Lighting

Lighting Instructions

To Turn Off Gas To Appliance

Optional Remote Operation

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.

A.	This a ppliance is equipped with an ignition de vice w hic h
	automatically lights the pilot. Do not try to light the pilot
	by hand.
B.	BEFORE LIGHTING smell all ar ound the a ppliance ar ea
	for gas. Be sur e to smell ne xt to the f loor because some g as
	is hea vier than air and will settle on the f loor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch.

•Do not use an y phone in y our b uilding .

•Immedia tely call y our g as supplier fr om a neighbor’ s phone . Follow the g as supplier’ s instr uctions.

•If you cannot r eac h your g as supplier , call the f ire department.

C. Do not use this a ppliance if an y par t has been under w ater. Immedia tely call a qualif ied ser vice tec hnician to inspect the appliance and to r eplace an y par t of the contr ol system and an y gas contr ol whic h has been under w ater.

LIGHTING

INSTRUCTIONS

NOTICE: During initial operation of new heater, burn- ing logs will give off a paper-burning smell. Orange flame will also be present. Open damper or window to vent smell. This will only last a few hours.

1.STOP! Read the saf ety information, above.

2.Turn off all electr ic po wer to the a ppliance .

3.Turn wall switch to the OFF position.

4.Open lo wer louv er panel.

5. Turn equipment shutof f valve c lockwise Clockwise to the OFF position (see F igure 47). Do not f orce .

6.Wait five (5) min utes to c lear out an y gas. Then smell f or gas, inc luding near the f loor. If you smell g as, STOP! Fol- low “B” in the saf ety information above. If you don’ t smell gas, go to the next step.

7.Turn equipment shutof f valve counter clockwise C-clockwiseto the ON position. Do not f orce .

8.Close lo wer louv er panel.

9.Turn on all electr ic po wer to the a ppliance .

10.Turn the w all switch to the ON position.

11. Visuallylocatethepilot. Theignitorshouldbe gintospar kand

the main b urner should ignite once f		lame a ppear s at pilot.
•	If lighting the a ppliance f or the f irst time eac h season, it
	may take se veral attempts bef ore the suppl y gas can r each
	the pilot and main b urner s.
•	If the a ppliance will not sta y lit after se ver al attempts,
	follow the instr uctions To Turn Off Gas To Appliance,
	below, and call y our ser vice tec hnician or g as supplier .
	Equipment Shutoff Valve	Adjustment
		Screw