Desa (V)K42EN, (V)K42EP installation manual Product Identification, Local Codes

SAFETY INFORMATION PRODUCT IDENTIFICATION LOCAL CODES

3

SAFETY INFORMATION

Continued

5.	This fireplace reaches high temperatures. Keep children and
	adults away from hot surfaces to avoid burns or clothing igni-
	tion. Fireplace will remain hot for a time after shutdown. Al-
	low surfaces to cool before touching.
6.	Carefully supervise young children when they are in the room
	with fireplace.

PRODUCT IDENTIFICATION

Upper Louver	Flue Collar
Panel

7.	Do not modify this fireplace under any circumstances. Any
	parts removed for servicing must be replaced prior to operat-
	ing fireplace.
8.	Turn fireplace off and let cool before servicing, installing, or
	repairing. Only a qualified service person should install, ser-
	vice, or repair this fireplace. Have fireplace inspected annu-
	ally by a qualified service person.
9.	You must keep control compartments, burners, and circulat-
	ing air passages clean. More frequent cleaning may be needed
	due to excessive lint and dust from carpeting, bedding mate-
	rial, etc. Turn off the gas valve and pilot light before cleaning
	fireplace.
10.	Have venting system inspected annually by a qualified service
	person. If needed, have venting system cleaned or repaired.
	See Cleaning and Maintenance, page 26.
11.	Keep the area around your fireplace clear of combustible ma-

Nailing

Flange

Glass

Door

Assembly

Lower

Louver

Panel

Log Set

Burner

Assembly

	terials, gasoline, and other flammable vapor and liquids. Do
	not run fireplace where these are used or stored. Do not place
	items such as clothing or decorations on or around fireplace.
12.	Do not use this fireplace to cook food or burn paper or other
	objects.
13.	Do not use any solid fuels (wood, coal, paper, cardboard, etc.)
	in this fireplace. Use only the gas type indicated on fireplace
	nameplate.
14.	This appliance, when installed, must be electrically grounded
	in accordance with local codes or, in the absence of local codes,
	with the National Electrical Code, ANSI/NFPA 70, or the Ca-
	nadian Electrical Code, CSA C22.1.
15.	Do not use fireplace if any part has been exposed to or under
	water. Immediately call a qualified service person to arrange
	for replacement of the unit.
16.	Do not operate fireplace if any log is broken.
17.	Do not use a blower insert, heat exchanger insert, or other ac-
	cessory not approved for use with this fireplace.
18.	Do not operate fireplace with glass door removed, cracked, or
	broken.
19.	Provide adequate clearances around air openings.

Control	Glowing	Lava Rock
	Embers
Valve
		Switch Bracket for
		Optional Remote
		and Blower

Figure 1 - Direct-Vent Fireplace with Electronic Ignition

LOCAL CODES

Install and use fireplace with care. Follow all local codes. In the absence to local codes, use the current National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current CSA-B149.1 Instal- lation Code (Canada).

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

For morevisit www..com

111922-01A