4
PRODUCT FEATURES
ASSEMBLING HEATER
Removing Front Panel Of Heater
Installing Hood
Installing Log
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent- free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
THERMOSTATIC HEAT CONTROL
This heater has a thermostat sensing bulb and a control valve. This results in the greatest heater comfort. This can also result in lower gas bills.
ASSEMBLING HEATER
Tools Required:
•Phillips screwdriver
•5/16" hex wrench
•slotted screwdriver
REMOVING FRONT PANEL OF HEATER
1.Remove two screws near bottom corners of front panel with Phillips screwdriver.
2.Pull bottom of front panel forward, then down (see Figure 2).
Figure 2 - Removing Front Panel of Heater
INSTALLING HOOD
1.Remove hood from protective tray.
2.Locate 4 black sheet metal screws from hardware pack.
3.Place hood on deflector and line up holes (see Figure 3).
4.Secure hood to deflector with 4 black sheet metal screws.
Note: Side of hood should be on the outside flange of deflector.
INSTALLING LOG
Note: For easier installation, lay heater on its back.
1.With Phillips screwdriver, remove two screws holding screen in place. Remove screen.
2.Remove log from inside of deflector. Discard protective packaging.
3.Gently slide log between log retaining brackets on deflector assembly (see Figure 3). The log should fit firmly against bot- tom of log retaining brackets.
4.Reattach screen using two screws removed in step 1.
| Heater | Deflector | |
Log | Log | ||
Cabinet | |||
|
| Retaining | |
|
| Brackets | |
| Hood |
| |
Front | Sheet |
| |
Panel |
| ||
Metal |
| ||
|
| ||
| Screw |
|
Truss-
Head
Screw
Nut |
| Burner |
|
| Shield |
Brass | Screen | Screw |
| ||
|
| |
Front Trim |
|
|
Screw
Figure 3 - Assembling Heater
WARNING: Always have burner shield and screen in place before operating heater. This prevents ex- cessive temperatures on heater surfaces.
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
For..com
109889