12
OPERATING APPLIANCE
Lighting Instructions (Cont.)
Remote Control Operations
OPERATING APPLIANCE
Continued
9.Slightly push in and turn control knob counterclockwise to the ON position.
10.Wait one minute and switch selector switch to the ON po- sition to light burners. Note: AUTO is not functional.
11.Set flame adjustment knob to any level between HI and LO.
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
WARNING: Make sure the selector switch is in the OFF position when you are away from home for long periods of time. Appliance will come on automatically with selector switch in the ON position.
| Ignitor | Pilot | Ignitor | |
Pilot | Electrode | |||
Burner | ||||
Burner | Electrode |
| ||
|
|
Figure 14 - Pilot (Propane/LP) | Pilot (Natural) |
TO TURN OFF GAS TO APPLIANCE
Shutting Off Appliance
1.Turn control knob clockwise to the OFF po- sition.
2a. Set selector switch in the OFF position.
2b. If Using Optional
MANUAL LIGHTING PROCEDURE
1.Follow steps 1 through 6 under Lighting Instructions.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, Lighting Instructions, column 1.
REMOTE CONTROL OPERATION
Remote Control Operation
GHRC Series Operation:
1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position. Note: The burners may light if
IMPORTANT: Do not leave the selector switch in the RE- MOTE or ON position when the pilot is not lit. This will drain the battery.
2.Press the ON/OFF button to turn the burners on and off. When turning burners off, the pilot will remain lit.
IMPORTANT: Be sure to press the ON/OFF buttons on the
Note: All additional remote control accessories must be pur- chased separately (see Accessories, page 22). Follow instructions included with the remote control.
| Selector Switch in |
|
|
Control Knob | OFF Position |
|
|
|
|
| |
F |
|
| REMOTE |
ILOT | O |
|
|
P |
|
| |
F | N |
|
|
O | OL | AUTO | OFF |
| |||
|
| OFF | ON |
|
| ON |
|
| HI |
|
|
Ignitor Button | Flame Adjustment Knob | Selector Toggle Switch | |
|
|
Shutting Off Burner Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing one of the following:
1.Turn control knob clockwise to the PILOT po- sition.
2.Use remote control manual OFF button.
3.Set selector switch in the OFF position.
Remote Control
Figure 15- Setting the Selector switch, Control Knob, and Flame Adjustment Knob for Remote Operation
For more information, visit www.desatech.com