Desa CHDV47NR, (V)V36N, CHDV47PR Installing Remote Receiver, Fireplace Installation, Continued

22

FIREPLACE INSTALLATION

Installing Optional Wireless Hand-Held Remote Control - RC, GHRC, CGHRC, (C)GHRCT(A) Series

FIREPLACE INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL - (C)GHRC AND (C)GHRCT(A) SERIES

NOTICE: Use only alkaline batteries (not included).

Installing Remote Receiver

Installing 9-Volt Alkaline Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to a 9-volt alkaline battery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

1.	Open bottom louver and locate the switch bracket on the left.
2.	Unscrew the switch bracket. Lean bracket forward so you are
	able to access the back of the remote receiver.
3.	Locate the battery clip mounted on the back of the receiver.
	Slide a 9-volt alkaline battery (not included) through the clip
	(see Figure 36).
4.	Attach the terminal wires to the battery.

Battery Cover

Terminal

Wires

9-Volt Alkaline Battery

Remote Control Unit

Battery

Housing

5.	Remove wire from TH to TPTH on control valve (see Figure 37).
6.	Connect wires from receiver to TH and TPTH to control valve
	(see Figure 38).
7.	Replace the switch bracket.

Receiver
9-Volt	Terminal
Alkaline
Battery	Wires
	Battery Clip

Figure 36 - Attaching Alkaline Battery to Receiver

Figure 39 - Installing Alkaline Battery in Hand-Held Remote Control Unit ([C]GHRC)

Terminal

9-Volt Wires

Battery

Remote

Control

Unit

Battery

Cover

Figure 40 - Installing Battery in Hand-Held Remote Control Unit ([C]GHRCT[A] Series)

Figure 37 - Disconnecting TH to TPTH Wire

To Optional

Remote

Accessory

Figure 38 - Control Valve Terminals

For..com

108861