Desa FPVF33NR, VYGF33NRA Optional Wireless HAND-HELD Remote, Installing 9-VOLT Batteries

INSTALLATION

Optional Wireless Hand-Held Remote Control Accessories

17

INSTALLATION

Continued

OPTIONAL WIRELESS HAND-HELD REMOTE

CONTROL ACCESSORIES (GHRC and

GHRCTA Series)

Installing Remote Receiver Unit

1.Disconnect switch wires from the control valve.

2.Remove screws attaching switchplate.

3.Remove switch plate (see Figure 33). Discard after removing.

4.Install remote receiver unit onto gas log heater base using mounting clips.

5.Push clips firmly into place (see Figure 34).

6.Connect wires as shown in Figure 35.

INSTALLING 9-VOLT BATTERIES

Two 9-volt batteries (not included) are required to operate this heater with the wireless hand held remote control set. Install one battery in the receiver and one in the hand-held remote control unit. Note: Only use alkaline batteries.

Installing 9-Volt Battery in Receiver

1.Locate back of receiver under front burner of heater.

2.Locate the battery clip mounted on the back of the receiver.

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Remote

Switch

Bracket

Screw

Ignitor

Remote	Terminal
Receiver
	Wires

Battery Clip

Switch Plate Wires

Figure 33 - Switch Plate and Wiring Harness

Mounting

Clips

Remote Receiver

Figure 34 - Installing Remote Receiver

White Wire

From

Receiver

Valve

Red Wire From

Receiver

Figure 35 - Connecting Wires

9-Volt Battery

Figure 36 - Installing Battery in Remote Receiver

Installing 9-Volt Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery. Place battery into the bat- tery housing.

3.Replace battery cover onto remote control unit.

	Model	Battery
Terminal	GHRC
		Cover	Remote
Wires			Control Unit
			Model
			GHRCTA

9-VoltBattery

BatteryHousing

Figure 37 - Installing Battery in Hand-Held Remote Control Unit

For morevisit www..com

105270