W26LC Wall Mantel and Base

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Important: Read entire instruction sheet before assembling or installing mantel kit.

This mantel is only approved for use with any DESA HeatingProducts26"gasorelectricfireplacesystem. Do not use mantel with any other product.

This mantel kit contains the following:

•Mantel pieces - unassembled and marked as follows: #1 Base

#2 Right Side with arrow

#3 Right Front Leg with arrow #4 Left Side with arrow

#5 Left Front Leg with arrow #6 Header with arrow

#7 Top

#8 Right Front Corner #9 Left Front Corner

•Hardware Kit*

6 - Metal Brackets

 

118937-01

12

- Screws M6 x 12 mm (1/2")

121149-01

21

- Screws M6 x 30 mm (1 1/4")

121335-01

21

- Washers M6

 

121336-01

1 - Allen Wrench

 

121337-01

*Extra hardware may be included.

 

• Perimeter Trim Kit

113140-02 (GAB6094)

If any wood pieces are missing or damaged, contact the dealer where you purchased this mantel for replacement. If hardware is missing or damaged, contact DESA Heating Products at 1-866-672-6040 for referral information. You can also visit DESA Heating Products’ technical service web site at www.desatech.com.

Note: Gather all mantel pieces together before assembling mantel.

WARNING: Use only 1/2" screws to attach metal angle brackets. Damage to mantel will result if other screws are used for this purpose.

Assembling Mantel

IMPORTANT: More than one person is required to assemble and lift mantel.

Estimated assembly time: 30 minutes.

When assembling mantel do not tighten screws completely until told to do so. There should be some play in the pieces to allow for proper alignment and best possible fit. It is very importantthatmorethanonepersonassemblemanteltogether. Panels must be held in proper alignment to each other while tightening screws to assure fewer gaps and proper surface alignment. When tightening screws, do not over tighten. This may cause threads to strip. For this reason, the supplied Al- len wrench should be used rather than a power screwdriver. Panels have threaded inserts installed at screw locations. Screws should start and turn easily in threaded holes when assembled according to instructions. Do not force screws into holes.

IMPORTANT: There is a serial number label inside of right side panel and on outside package. When calling to request technical assistance or for replacement parts please have that number ready.

www.desatech.com