Leg Assembly

1.Lay right side panel (#2) face down on a soft surface to avoid marking finish. Attach right front corner (#8) to side

panel with three 1 1/4" screws with washers as shown in Figure 1. Attach leg front (#3) to front corner (#8) with three 1 1/4" screws with washers as shown in Figure 1.

2.Assemble left side (#4), left leg (#5) and left corner (#9) as described in step 1.

3.Attach 6 brackets to base (#1) at threaded hole locations using 1/2" screws leaving screws loose. Face brackets toward outside (see Figure 2).

Leg Front (#3)

1 1/4" Screw with Washer

Front

Corner (#8)

Leg Side (#2)

4.Place right side/leg assembly on base and align threaded holes with brackets. Start 1/2" screws through brackets into threaded holes in side/leg assembly. Back of side/ leg assembly should be flush with back of base. Assure alignment is correct and spaces are at a minimum and tighten leaving screws slightly loose.

5.Assemble left side/leg assembly to base (#1) following step #4.

Header Assembly

With arrow pointing up, place header (#6) into position on top of leg assemblies and against front corner pieces (see Figure 3). Start two 1 1/4" screws with washers through each end of header and into front corners. Hold header in proper alignment with leg assemblies and tighten, leaving screws slightly loose.

1 1/4" Screw with Washer

Header (#6)

Figure 1 - Leg Assemblies (right side shown)

Right

Side/LegFigure 3 - Attaching Header

Assembly

Base (#1)

Bracket

1/2" Screw

Figure 2 - Leg Assembly to Base

www.desatech.com

121498-01A