Mantel Top Assembly
Place mantel top (#7) on mantel assembly. Align back of top with back of sides. Using four 1 1/4" screws with washers, place two in each mantel side assembly (see Figure 4). With one 1 1/4" screw with washer, attach top to header. Make sure all pieces are aligned properly and tighten, leaving screws slightly loose.
Mantel Top (#7)
1 1/4" Screw with Washer
Mantel Side | Header | |
Assembly | ||
|
Gas Fireplace Installation
1.Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual.
2.Place mantel base close to installation location. See fire- place owner’s manual for installation clearances. Leave enough room to insert fireplace from back of mantel.
3.Install gas line. See Connecting to Gas Supply in fireplace owner’s manual. Remember to leave access to the gas shutoff valve somewhere on the base or where it is ac- cessible to the user.
4.Check for leaks. See Checking Gas Connections in fire- place owner’s manual.
5.Position fireplace inside mantel (see Figure 6). Carefully position gas lines. Important: Use caution when position- ing fireplace on base. Base may scratch easily. Make sure fireplace is in proper position within mantel opening before continuing with installation.
6.Fireplace with louver door: Lower bottom louver door. Use two screws provided in hardware package and attach fireplace to wooden base. Close louver door.
Fireplace with fixed louver: Before installing logs or burner assembly (see owner’s manual) remove screws securing floor to assembly. Lift floor for access to bot- tom of fireplace. Use two screws provided in fireplace hardware package and attach fireplace base to wooden base. Reinstall floor with screws removed previously.
7.If mantel trim has not yet been assembled, see Assem- bling Perimeter Trim, page 4. Place metal trim on shoulder screws. Firmly snap trim assembly over shoulder screws on fireplace.
8.Carefully push mantel and base into position against wall.
Figure 4 - Attaching Mantel Top
Finishing Mantel
Starting with left side leg assembly, tighten screws using Allen wrench provided. Tighten screws on the right side leg assembly, header, top assembly and base.
Figure 6 - Installing Fireplace
www.desatech.com |