1 1/4" |
|
Screw | Long Wood |
| |
| Block |
Short Wood |
|
Block |
|
Dimplex |
|
Header |
|
Figure 5 - Attaching Blocks to Dimplex Header | |
1 1/4" Screw | Mantel |
| Header |
Long Wood
Block
3.Attach supplemental brackets using 1/2" or 3/4" screws provided in bracket hardware kit. Use 3 brackets to attach top to mantel assembly - one at back of each leg assembly and one at center of header (see Figure 8).
4.Place mantel base next to wall at installation location. See fireplace owner's manual for installation clearances.
5.Place mantel assembly onto mantel base and center left to right with the back flush with the back of the base (see Figure 9).
6.Use 1 1/4" screws in pocket holes to attach mantel assem- bly to mantel base. Using brackets and 1/2" - 3/4" screws from bracket hardware kit, attach support brackets to base and mantel assembly - one at each back corner of the leg sides and one on each leg front (see Figure 9).
Small Gap Between
Header and Top
Short Wood
Block
Dimplex
Kit Header
Make certain |
| |
spacing is |
| |
the same | Bracket | |
front and | ||
1/2" or 3/4" | ||
back. | ||
| Screw |
Legs Should Be Flush With Top
1 1/4"
Screws
Figure 6 - Mantel Kit Installation for Dimplex
Attaching Top of Mantel
1.Place top onto mantel (see Figure 7). The rear of legs should be flush with back of mantel top and centered left to right (see Figure 7).
2.Make sure mantel is centered left to right inside top and rear of legs are flush with back of top. Gap between mantel top and leg should be the same from front to back (see Figure 8). Use 1 1/4" screws through pocket holes in the side assemblies and the front to attach top of mantel.
Mantel
Top
Header
Leg
Assembly
Figure 7 - Placing Mantel Top Onto Mantel Assembly
Figure 8 - Attaching Mantel Top to Leg and Header Assembly
1 1/4" Screws
1/2" or 3/4" Screw
Bracket 
Mantel Base
Figure 9 - Attaching Mantel Assembly to Mantel Base
www.desatech.com |
