Assembling metal Trim Included with Gas Fireplace
1.Remove packaging from three pieces of metal trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 10.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 10).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 10).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 2 through 6 for other corner.
Set Screws | Slot |
Adjusting | Top Trim |
| |
Plate | Mitered Edge |
Shim | Side Trim |
| Slot |
Figure 10 - Assembling Metal Trim
Installing FireplacE
1.Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual.
2.Install gas line. See Connecting To Gas Supply in fireplace owner’s manual. Remember to leave access to the gas shutoff valve somewhere on the base or where it is ac- cessible to the user.
3.Check for leaks. See Checking Gas Connections in fire- place owner’s manual.
4.Position firebox inside mantel, carefully positioning gas lines. IMPORTANT: Use caution when positioning fireplace on base. Base may scratch easily.
5.Place trim kit on the shoulder screws located on the side and top of the fireplace. Firmly snap the trim over the shoulder screws on fireplace (see Figure 11). Align fireplace in mantel assembly so that the trim overlaps the mantel evenly on all three sides.
6.Firebox with louver door: Lower bottom louver door. Use two 3" screws provided in hardware package and attach fireplace/box to wooden base (see Figure 12).
Close louver door.
Firebox with fixed louver: Before installing logs or burner assembly (see owner's manual) remove screws securing floor to assembly. Lift floor for access to bottom of firebox. Use two 3" screws provided in fireplace hardware package and attach fireplace base to wooden base (see Figure 13). Reinstall floor with screws removed previously.
Bottom
Louver
Door
Hole for 3" Screw for Attaching
Fireplace System to Wooden
Mantel Base
Shoulder
Screw
Assembled
Trim
Figure 11 - Inserting Fireplace Into Cabinet Mantel
Figure 12 - Attaching Fireplace to Mantel and Mantel Base
Screws |
Fixed | Holes are Behind Louver on | |
Louver | ||
Firebox Bottom for Attaching | ||
| ||
| Firebox to Wooden Mantel Base. |
Figure 13 - Screw Locations for Fireboxes with Fixed Louver
2701 Industrial Drive |
|
P.O. Box 90004 | |
Bowling Green, KY | Rev. A |
Technical Service and Parts: | 07/06 |
