Desa Tech CBN30T, CBP20 Attaching Mounting Bracket To Wall, Placing Heater On Mounting Bracket

INSTALLATION

Installing Heater To Wall (Cont.)

9

INSTALLATION

Continued

2.Mark screw locations on wall (see Figure 8).

Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.

3.Remove tape and mounting bracket from wall.

12"	14"
Min.

AdjoiningWall	Only Insert Mounting	18 3/4"
	Screws Through Last	Min.
	Hole On Each End
	Floor
30,000 Btu/hr Models
8"	14"
Min.
AdjoiningWall	Only Insert Mounting 18 3/4"
	Screws Through Last	Min.
	Hole On Each End

Floor

20,000 Btu/hr Models

Figure 8 - Mounting Bracket Clearances

Attaching Mounting Bracket To Wall

Note: Wall anchors, mounting screws, and spacers are in hardware package. The hardware package is provided with heater.

Attaching To Wall Stud Method

For attaching mounting bracket to wall studs

1. Drill holes at marked locations using 9/64" drill bit.

2. Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall.

3. Insert mounting screws through bracket and into wall studs.

4. Tighten screws until mounting bracket is firmly fastened to wall studs.

Attaching To Wall Anchor Method

For attaching mounting bracket to hollow walls (wall areas between studs) or solid walls (concrete or masonry)

1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1" deep.

2.Fold wall anchor as shown in Figure 9.

3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.

4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings. IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

5.Place mounting bracket onto wall. Line up last hole on each end of bracket with wall anchors.

6.Insert mounting screws through bracket and into wall anchors.

7.Tighten screws until mounting bracket is firmly fastened to wall.

Placing Heater On Mounting Bracket

1.Locate two horizontal slots on back panel of heater.

2.Place heater onto mounting bracket. Slide horizontal slots onto stand-out tabs on mounting bracket.

Figure 9 - Folding Anchor	Figure 10 - Popping Open
	Anchor Wings For Thin Walls

Horizontal Slots

Stand-Out Tab	Mounting Bracket
	(attached to wall)

Figure 11 - Mounting Heater Onto Mounting Bracket

For morevisit www..com

107882-01E