PROPANE CONSTRUCTION HEATER
PROPANE SUPPLY
you must provide the propane gas and cylinder(s). use this heater only with a propane vapor withdrawal supply system. Refer to chapter 5 of the standard for storage and handling of liquefied petroleum gas, ansi/nfpa 58. your local library or fire department will have this booklet.
•The cylinder must be equipped with a collar to protect the gas valve, an arrangement of vapor withdrawal, a shutoff valve terminating the cylinder valve outlet as specified in the american national standard for compressed gas cylinder valve outlet and inlet connections, and a safety relief valve in direct contact with the vapor space of the tank.
•always keep the cylinder in an upright position. avoid knocking the cylinder over on its side with the hose/ regulator connected, as this can cause damage to the regulator diaphragm.
•never store a propane (lp) cylinder indoors or in the vicinity of any gas burning appliances.
•protect the cylinder valve, and handle it with care.
•Be sure that the
•Be sure to protect the pol fitting from damage when disconnected. damage to this fitting can lead to leaks.
•The hose assembly shall be visually inspected prior to each use of the heater. if it is evident that there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the heater being put into operation. The replacement hose assembly shall be that specified by the manufacturer.
•never connect an unregulated cylinder to the heater. always use the hose and regulator supplied.
•never use any other hose and regulator.
•do not subject the cylinder to excessive heat.
7
