Pressure Release Valve: The pressure release valve located on the side of the pressure switch, is designed to automatically release compressed air from the compressor head and the outlet tube when the air compressor reaches
shut off. The pressure release valve allows the motor to restart freely. When the motor stops run-
ning, air will be heard escaping from this valve for a few seconds. No air should be heard leaking when
the motor is running, or continuous leaking after unit reaches
How to Use Your Unit
How to Stop:
1.Set the On/Auto/Off lever to “OFF”.
Before Starting
Break-in Procedure
Serious damage (for units with a tank) may result if the following
This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.
1.Make sure the On/Auto/Off lever is in the "OFF" position.
NOTE: Pull coupler back until it clicks to prevent air from escaping through the quick connect.
2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)
3.Open the drain valve fully (counterclockwise) to permit air to escape and prevent air pressure build up in the air tank during the
4.Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will start.
5.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure
6.After 15 minutes, close the drain valve (clockwise). The air receiver will fill to
The compressor is now ready for use.
Before Each Start-Up:
1.Place On/Auto/Off lever to “OFF”.
2.Pull regulator knob out, turn counterclockwise until it stops. Push knob in to lock in place.
3.Attach hose and accessories. NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect socket.
13- ENG | D23757 |
