Too much air pressure causes a hazardous risk of bursting. Check the manufacturer’s maximum
pressure rating for air tools and accessories. The regulator outlet pres- sure must never exceed the maximum pressure rating.
How to Start:
1.Turn the On/Auto/Off lever to “AUTO” and allow tank pressure to build. Motor will stop when tank pressure reaches
2.Pull the regulator knob out and turn clockwise to increase pressure. When the desired pressure is reached push knob in to lock in place. The com- pressor is ready for use.
NOTE: Always operate the air compressor in
| MAINTENANCE |
| |
Customer Responsibilities |
|
| |
|
|
|
|
| Before each use | Daily or after |
|
| each use |
| |
|
|
| |
Check Safety Valve | ● |
|
|
|
|
|
|
Drain Tank |
| ● |
|
To Check Safety Valve
If the safety valve does not work properly, over- pressurization may occur, causing air tank rupture
or an explosion. Before starting compressor, pull the ring on the safety valve to make sure that the safety valve operates freely. If the valve is stuck or does not operate smoothly, it must be replaced with the same type of valve.
To Drain Tank
1.Set the On/Auto/Off lever to “OFF”.
2.Pull the regulator knob out and turn clockwise to set the outlet pressure to zero.
3.Remove the air tool or accessory.
4.Pull ring on safety valve allowing air to bleed from the tank until tank pres- sure is approximately 20 psi. Release safety valve ring.
5.Drain water from air tank by opening drain valve
Water will condense in the air tank. If not drained, water will corrode and weaken the air tank causing
a risk of air tank rupture.
6.After the water has been drained, close the drain valve (clockwise). The air compressor can now be stored.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.
D23757 | 14- ENG |
