Assembly for Vertical units | DeVillbiss Air Power Company D26368

Assembly for “Vertical” units

1 - 9/16” socket or open end wrench

1 - 1/2” socket or open end wrench

1.Remove all packaging leaving the air compressor on the pallet.

2.Remove and discard the (4) screws holding the air compressor to the pallet.

It may be necessary to
brace or support one	Screws

side of the air compressor when

removing the pallet because the air compressor will have a tendency to tip.

3.Carefully remove the air compressor from the pallet.

It will be necessary to brace or support one side of the outfit when installing the wheels because the compressor

will have a tendency to tip.

4.Attach wheels with shoulder bolts and nuts as shown.

5.Tighten securely. NOTE: The unit will sit level if the wheels are properly installed.

The wheels and handle do not provide adequate clearance, stability or support for pulling the unit up and

down stairs or steps. The unit must be lifted, or pushed up a ramp.

6.Attach rubber feet with the screws provided as shown in previous figure.

7.Tighten snug or until rubber foot begins to compress.