Assembly for “Horizontal” units
Tools Required for Assembly
1 - 9/16” socket or open end wrench
1 - 3/8” socket or open end wrench
1 - 1/2” socket or open end wrench
1.(if equipped) To make installation easier, submerge handle grip into warm soapy water. Remove handle
grip from soapy water and slide onto handle.
Handle Grip
2.Insert the handle inside the
compressor saddle and line up the two bolt holes on each side.
3.Install the four screws, two on each side.
Screw
Handle
4.Tighten securely.
It will be necessary to
brace or support one side of the outfit when installing the wheels because the compressor will have a tendency to tip.
Rubber Feet
Screw
Nut
Wheel
Shoulder Bolt
Rubber Strip
5.Attach wheels with shoulder bolts and nuts as shown. NOTE: Place the bolts in the bottom hole of the wheel bracket on units
6.Tighten securely. NOTE: The outfit will sit level if the wheels are properly installed.
The wheels and handle do not provide adequate clearance, stability or support for pulling the unit up and
down stairs or steps. The unit must be lifted, or pushed up a ramp.
7.The unit will be equipped with rubber feet or a rubber strip
a.(rubber strip) Clean and dry underside of air tank leg opposite wheels. Remove the protective paper strip from the adhesive backed rubber foot strip. Attach the rubber foot strip to the bottom of leg. Press firmly into place.
b.(rubber feet) Attach rubber feet with the screws provided as shown in previous figure. Tighten securely.
11- ENG | D26368 |
