DeVillbiss Air Power Company ENS150, ENS100 EMPLOYER’S Responsibilities, Functional Description

EMPLOYER’S RESPONSIBILITIES

Employer must enforce compliance with the safety warnings and all other instructions contained in this manual.

Keep this manual available for use by all people assigned to use this tool.

For personal safety and proper operation of this tool, read and understand tool labels and manual. Failure to follow warnings could result in DEATH or SERIOUS INJURY. Read and follow all of these instructions carefully.

FUNCTIONAL DESCRIPTION

Ex-Cell Model ENS100 is designed to install generic 18 ga. narrow (1/ 4") crown staples of various lengths from 1/ 2" to 1" long. Narrow crown staples are loaded into the magazine from the bottom.

Ex-Cell Model ENS150 is designed to install generic 18 ga. narrow (1/ 4") crown staples of various lengths from 1/ 2" to 11/ 2" long. Narrow crown staples are loaded into the magazine from the bottom.

Ex-Cell stapling tools are compact, lightweight, high performance tools designed for molding, interior trim, paneling, cabinetry, picture/mirror frames and crafts. Features include jam release mechanism, tool free adjustable exhaust, fastener reload indicator, safety positioned on rear of nose and a removable rubber nose cushion.

CARTON CONTENTS

1)	Stapler	3)	Air Tool Oil Bottle
2)	Staples	4)	Owner's Manual

POWER SOURCE

This tool is designed to operate on clean, dry, compressed air at regulated pressures between 70 and 110 PSI (Pounds per Square Inch)(4.8 to 7.6 BAR). The preferred system would include a filter, a pressure regulator, and an automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is ideal. The tool is equipped with a 1/ 4" male “quick connector”.

All compressed air contains moisture and other contaminates that are detrimental to internal components of the tool. An air line filter will remove most of these contaminates and significantly prolong the life of the tool. If an in-line oiler is not available: place five or six drops of Air Tool Oil into the tool’s air inlet at the beginning of each workday.

7